Hi Strato,
Also, it has just been pointed out to me that 177 is running 5.4 and the others 5.3.2. Did you do the upgrade part way through the tests? Where have you installed the App Center for the clients?
Regards,
Yvonne
Hi Strato,
Also, it has just been pointed out to me that 177 is running 5.4 and the others 5.3.2. Did you do the upgrade part way through the tests? Where have you installed the App Center for the clients?
Regards,
Yvonne
yes, this is a test environment for now, no matter what client we use for it. And yes, I upgraded the 177 to 5.4 (AppBuilder runs on this machine). We installed AppCenter on each client machine separately. Yes, we have installed 5.3.2 before and have not updated any of them
Hi Strato,
On 96, if you remove the --runtimedir switch from the shortcut, does it correctly load the App Center (and show the '...no published Apps...' message)?
Regards,
Yvonne
Hi Yonne,
yes, exactly:
(of course I can only log in as admin)
hi Yvonne,
I have additional issues running the App runtime. Where I can start the AppCenter , it will report an error immediately after starting. In the ready delegate, the first statement is do sp_setup. Sp_setup.prg is in the thirdpartylibs folder, and the app works well in AppBilder. The deployment is ok in principle - I think - , sp_setup.dbo is transferred to the network drive .
What do I do wrong?
Hi Strato,
Can you add the '--debug' command line switch to your shortcut, then run again. After exiting the App Center, check the debug folder on the client and submit a ticket (sign in required) with the most recent debug_client_XXXX.txt file along with the client's lianja\log\log.txt file.
Regards,
Yvonne
Also, for your earlier blank App Center screen - do you get any error messages displayed as you start the App Center?
Can you try it with the --tenancy switch? For --tenancy you specify the relevant tenancy directory, default is public, so for you:
Code:--tenancy G:\pulinfo\lianja\lianja\cloudserver\tenants\public\
good news: after reinstalling AppCenter (5.4) all three clients work fine with the same two parameters (--runtimedir --tenancy)
bad news: Apps don't work well. Apps don't "see" the Page's (and Section's) custom library file (I'm getting error messages about missing procedures in these files)
good news: i was lame, I messed up the deployment
can I use the --debug switch with AppCenter?
if so, where are the debug files?
Bookmarks